HGW HT
WATER - WATER AND BRINE - WATER HEAT PUMPS FOR INDOOR INSTALLATION
Available range
Unit type
IH Heat pump
IP Reversible heat pump (reversible on the refrigerant side)
Versions (heat recovery)
VB Base version
VD Desuperheater version
Acoustic setting up
AB Base setting up
AS Low noise setting up
-
Technical Data
This series of water-water heat pumps satisfies the heating, cooling and domestic hot water production requirements of autonomous or centralized residential plants of medium and large size. All the units are suitable for indoor installation. The possibiliy to produce water at high temperatures makes these units particularly suitable to be applied to radiators plants as well as to fan coil plants and radiant floor plants.
As source both water (from well, river, lake…) or brine solutions (from geothermic probes) can be used. The control system allows to manage not only the refrigerant circuit but the whole plant with the possibility to choose different solutions both for the heating and cooling plant and for the domestic hot water management. The possibility of solar panels or other heating sources integration is also available.
The heating function optimizes the flow water temperature according both to the ambient temperature and to the outdoor temperature through climatic curves adaptable to the building features. It’s possible to manage a storage tank and two independent circuits (a direct one and a mixed one). The domestic hot water management allows to control the three way valve, the storage tank and the anti-legionella cycles (if necessary). The cooling function can be realized through “passive cooling” (free cooling), through “active cooling” (refrigerant circuit inversion) or through both systems actuated in sequence. When the unit is used in radiant floor plants, to avoid condensate generation, a room humidity sensor can be installed. During cooling mode operation a part of the heating power in excess can be recovered for the domestic hot water production (VD version).
The internal programmer clock allows to define different daily switching programs for heating, cooling and domestic hot water production.
The refrigerant circuit is equipped with scroll compressors mounted on damper supports, brazed plate heat exchangers, electronic expansion valve and reverse cycle valve (for reversible units). The circuit is protected by high and low pressure switches and flow switches on both the exchangers. The compressors are arranged in tandem on a single refrigerant circuit and allow the capacity modulation according to the plant requests in order to guarantee a high seasonal efficiency.
Both the compresors are equipped with vapour and liquid injection and are placed on an economized refrigerant circuit equipped with a plate heat exchanger and an electronic expansion valve dedicated to the injection. In the low noise setting up units (AS) the outdoor structure is thermally and acoustically insulated in order to reduce sound propagation and to allow the installation in domestic places.
The heat exchangers and all the hydrau- lic pipes are thermally insulated to avoid condensate generation and reduce thermal losses. All the units are supplied with phase sequence and voltage controller and with an outdoor temperature sensor in order to realize the climatic control.
All the units are accurately built and indi- vidually tested in the factory. Only electric and hydraulic connections are required for installation.
Options
Plant side flow rate management
• not present
• standard pump
• high head pump
• modulating pump
Source side flow rate management
• not present
• standard pump
• high head pump
• modulating pump
• 2 way valve
Domestic hot water production
• not present
• 3 way valve
Passive cooling
• not present
• standard
Soft starter
• not present
• standard
Accessories
Rubber vibration dampers
Spring vibration dampers
Remote thermostat (wired or wireless)
Remote control (wired or wireless)
Wireless transmitter
Wireless repeater
Condensate sensor
Room hygrostat
Room humidity sensor
-
Technical Files